User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Interface Commands
6-73
speed
This command configures the maximum data rate at which a
station can connect to the access point.
Syntax
speed <speed>
speed - Maximum access speed allowed for wireless clients.
(Options: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps)
Default Setting
54 Mbps
Command Mode
Interface Configuration (Wireless)
Command Usage
The maximum transmission distance is affected by the data
rate. The lower the data rate, the longer the transmission
distance. Please refer to the table for maximum distances on
page A-4.
Example
SMC-AP(if-wireless g)#speed 6
SMC-AP(if-wireless g)#