User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Interface Commands
6-65
interface
This command configures an interface type and enters interface
configuration mode.
Syntax
interface <ethernet | wireless <a | g>>
• ethernet - Interface for wired network.
• wireless - Interface for wireless clients.
• a - 802.11a radio interface.
• g - 802.11g radio interface.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the
following command:
show interface wireless Shows the status for the
wireless interface
Exec 6-93
show station Shows the wireless clients
associated with the access
point
Exec 6-94
SMC-AP(config)#interface ethernet
SMC-AP(if-ethernet)#
Command Function Mode Page