User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Command Line Interface
6-62
Interface Commands
The commands described in this section configure connection
parameters for the Ethernet port and wireless interface.
Command Function Mode Page
General Interface
interface Enters specified interface
configuration mode
GC 6-65
Ethernet Interface
dns primary-server Specifies the primary name
server
IC-E 6-66
dns secondary-server Specifies the secondary
name server
IC-E 6-66
ip address Sets the IP address for the
Ethernet interface
IC-E 6-67
ip dhcp Submits a DHCP request for
an IP address
IC-E 6-68
shutdown Disables the Ethernet
interface
IC-E 6-69
speed-duplex Configures speed and duplex
operation
IC-E 6-70
show interface ethernet Shows the status for the
Ethernet interface
Exec 6-71
Wireless Interface
description Adds a description to the
wireless interface
IC-W 6-71
closed-system Closes access to clients
without a pre-configured
SSID
IC-W 6-72