User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Command Line Interface
6-58
Command Usage
This command can disable wireless-to-wireless
communications between clients via the access point.
However, it does not affect communications between wireless
clients and the wired network.
Example
filter ap-manage
This command prevents wireless clients from accessing the
management interface on the access point. Use the no form to
disable this filtering.
Syntax
filter ap-manage
no filter ap-manage
Default
Disabled
Command Mode
Global Configuration
Example
SMC-AP(config)#filter local-bridge
SMC-AP(config)#
SMC-AP(config)#filter ap-manage
SMC-AP(config)#