User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
802.1x Port Authentication
6-53
• An entry in the address table may be allowed or denied
access depending on the global setting configured for the
address entry default command.
Example
Related Commands
address filter default (page 6-51)
show authentication (page 6-56)
address filter delete
This command deletes a MAC address from the filter table.
Syntax
address filter delete <mac-address>
mac-address - Physical address of client. (Enter six pairs of
hexadecimal digits separated by hyphens.)
Default
None
Command Mode
Global Configuration
Example
Related Commands
show authentication (page 6-56)
SMC-AP(config)#address filter entry 00-70-50-cc-99-1a
allowed
SMC-AP(config)#
SMC-AP(config)#address filter delete 00-70-50-cc-99-1b
SMC-AP(config)#