User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Command Line Interface
6-40
server is 255 characters or 32 characters for files on the
access point. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the access point
supports only two operation code files.
• The system configuration file must be named “syscfg” in all
copy commands.
Example
The following example shows how to upload the configuration
settings to a file on the TFTP server:
The following example shows how to download a configuration
file:
delete
This command deletes a file or image.
Syntax
delete filename
filename - Name of the configuration file or image name.
Default Setting
None
SMC-AP#copy config tftp
TFTP Source file name:syscfg
TFTP Server IP:192.168.1.19
SMC-AP#
SMC-AP#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:2
TFTP Source file name:syscfg
TFTP Server IP:192.168.1.19
SMC-AP#