User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Network Configuration
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- description
- closed-system
- speed
- channel
- turbo
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Cables and Pinouts
- Appendix C Specifications
- Glossary
- Index
Command Line Interface
6-34
Command Mode
Global Configuration
Example
Related Commands
snmp-server location (page 6-36)
snmp-server enable server
This command enables SNMP management access and also
enables this device to send SNMP traps (i.e., notifications). Use
the no form to disable SNMP service and trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure
notifications and link-up-down notifications.
• The snmp-server host command specifies the host device
that will receive SNMP notifications.
Example
SMC-AP(config)#snmp-server contact Paul
SMC-AP(config)#
SMC-AP(config)#snmp-server enable server
SMC-AP(config)#