User's Manual

Command Line Interface
6-32
SNMP Commands
Controls access to this access point from management stations
using the Simple Network Management Protocol (SNMP), as well
as the hosts that will receive trap messages.
snmp-server community
This command defines the community access string for the
Simple Network Management Protocol. Use the no form to
remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
• string - Community string that acts like a password and
permits access to the SNMP protocol. (Maximum length: 23
characters, case sensitive)
Command Function Mode Page
snmp-server
community
Sets up the community access string
to permit access to SNMP
commands
GC 6-32
snmp-server
contact
Sets the system contact string GC 6-33
snmp-server
enable server
Enables SNMP service and traps GC 6-34
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 6-35
snmp-server
location
Sets the system location string GC 6-36
show snmp Displays the status of SNMP
communications
Exec 6-37