User's Manual

System Management Commands
6-17
prompt
This command customizes the CLI prompt. Use the no form to
restore the default prompt.
Syntax
prompt string
no prompt
string - Any alphanumeric string to use for the CLI prompt.
(Maximum length: 255 characters)
logging level Defines the minimum severity level for
event logging
GC 6-23
logging
facility-type
Sets the facility type for remote logging
of syslog messages
GC 6-24
show logging Displays the state of logging Exec 6-25
System Clock Sets the system clock via an NTP/
SNTP server
sntp-server ip Specifies one or more time servers GC 6-25
sntp-server
enable
Accepts time from the specified time
servers
GC 6-26
sntp-server
date-time
Manually sets the system date and
time
GC 6-27
sntp-server
daylight-saving
Sets the start and end dates for
daylight savings time
GC 6-28
sntp-server
timezone
Sets the time zone for the access
point’s internal clock
GC 6-29
show sntp Shows current SNTP configuration
settings
Exec 6-29
System Status Displays system configuration and
version information
show system Displays system information Exec 6-30
show version Displays version information for the
system
Exec 6-31
Command Function Mode Page