User's Manual
Table Of Contents
- Chapter 1: Introduction 1-1
- Chapter 1: Introduction
- Chapter 2: Hardware Installation
- Chapter 3: Network Configuration
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Chapter 6: Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Appendix A: Troubleshooting
- Appendix B: Cables and Pinouts
- Appendix C: Specifications
- Glossary
- Index
Command Line Interface
6-94
6
beacon-interval Configures the rate at which beacon signals are
transmitted from the access point
IC-W 6-101
dtim-period Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
IC-W 6-102
fragmentation- length Configures the minimum packet size that can be
fragmented
IC-W 6-102
rts-threshold Sets the packet size threshold at which an RTS must
be sent to the receiving station prior to the sending
station starting communications
IC-W 6-103
super-a Enables Atheros proprietary Super A performance
enhancements
IC-W (a) 7-105
super-g Enables Atheros proprietary Super G performance
enhancements
IC-W (b/g) 6-104
description Adds a description to the wireless interface IC-W-VAP 6-104
ssid Configures the service set identifier IC-W-VAP 6-105
closed system Opens access to clients without a pre-configured
SSID
IC-W-VAP 6-105
max-association Configures the maximum number of clients that can
be associated with the access point at the same time
IC-W-VAP 6-106
assoc- timeout-interval Configures the idle time interval (when no frames are
sent) after which a client is disassociated from the
VAP interface
IC-W-VAP 6-106
auth- timeout-value Configures the time interval after which clients must
be re-authenticated
IC-W-VAP 6-106
shutdown Disables the wireless interface IC-W-VAP 6-107
show interface wireless Shows the status for the wireless interface Exec 6-108
show station Shows the wireless clients associated with the access
point
Exec 6-109
Table 6-17. Wireless Interface Commands
Command Function Mode Page