User's Manual
Table Of Contents
- Chapter 1: Introduction 1-1
- Chapter 1: Introduction
- Chapter 2: Hardware Installation
- Chapter 3: Network Configuration
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Chapter 6: Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Appendix A: Troubleshooting
- Appendix B: Cables and Pinouts
- Appendix C: Specifications
- Glossary
- Index
Command Line Interface
6-40
6
SNMP Commands
Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 6-9. SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit access
to SNMP commands
GC 6-41
snmp-server contact Sets the system contact string GC 6-41
snmp-server location Sets the system location string GC 6-42
snmp-server enable server Enables SNMP service and traps GC 6-42
snmp-server host Specifies the recipient of an SNMP notification
operation
GC 6-43
snmp-server trap Enables specific SNMP notifications GC 6-44
snmp-server engine id Sets the engine ID for SNMP v3 GC 6-46
snmp-server user Sets the name of the SNMP v3 user GC 6-46
snmp-server targets Configures SNMP v3 notification targets GC 6-48
snmp-server filter Configures SNMP v3 notification filters GC 6-49
snmp-server
filter-assignments
Assigns SNMP v3 notification filters to targets GC 6-50
show snmp groups Displays the pre-defined SNMP v3 groups Exec 6-50
show snmp users Displays SNMP v3 user settings Exec 6-51
show snmp
group-assignments
Displays the assignment of users to SNMP v3 groups Exec 6-51
show snmp target Displays the SNMP v3 notification targets Exec 6-52
show snmp filter Displays the SNMP v3 notification filters Exec 6-52
show snmp
filter-assignments
Displays the SNMP v3 notification filter assignments Exec 6-53
show snmp Displays the status of SNMP communications Exec 6-54