User's Manual
Table Of Contents
- Chapter 1: Introduction 1-1
- Chapter 1: Introduction
- Chapter 2: Hardware Installation
- Chapter 3: Network Configuration
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Chapter 6: Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Appendix A: Troubleshooting
- Appendix B: Cables and Pinouts
- Appendix C: Specifications
- Glossary
- Index
System Configuration
5-84
5
AP System Configuration – The AP System Configuration table displays the basic
system configuration settings:
• System Up Time: Length of time the management agent has been up.
• MAC Address: The physical layer address for this device.
• System Name: Name assigned to this system.
• System Contact: Administrator responsible for the system.
• IP Address: IP address of the management interface for this device.
• IP Default Gateway: IP address of the gateway router between this device and
management stations that exist on other network segments.
• HTTP Server: Shows if management access via HTTP is enabled.
• HTTP Server Port: Shows the TCP port used by the HTTP interface.
• Version: Shows the version number for the runtime code.
AP Wireless Configuration – The AP Wireless Configuration tables display the radio
and VAP interface settings listed below. Note that Interface Wireless G refers the
802.11b/g radio.
• SSID: The service set identifier for the VAP interface.
• Radio Channel: The radio channel through which the access point communicates
with wireless clients.
• Encryption: The key size used for data encryption.
• Authentication Type: Shows the type of authentication used.
• 802.1X: Shows if IEEE 802.1X access control for wireless clients is enabled.