User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Network Configuration
- Chapter 3 Hardware Installation
- Chapter 4 Initial Configuration
- Chapter 5 System Configuration
- Chapter 6 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- General Commands
- System Management Commands
- SNMP Commands
- Flash/File Commands
- RADIUS Client
- 802.1x Port Authentication
- Filtering Commands
- Interface Commands
- interface
- dns server
- ip address
- ip dhcp
- shutdown
- speed-duplex
- show interface ethernet
- radio-mode
- select-antenna-mode
- description
- ssid-broadcast
- closed-system
- speed
- channel
- ssid
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- authentication
- encryption
- key
- transmit-key
- transmit-power
- max-association
- multicast-cipher
- wpa-clients
- wpa-mode
- wpa-preshared-key
- wpa-psk-type
- shutdown
- show interface wireless
- show station
- IAPP Commands
- VLAN Commands
- Appendix A Troubleshooting
- Appendix B Specifications
- Appendix C Cables and Pinouts
- Glossary
- Index
System Configuration
5-28
Confirm New Password – Enter the password again for
verification.
CLI Commands for the User Name and Password – Use the
username and password commands from the CLI configuration
mode.
Upgrading Firmware
You can upgrade new SMC2552W-G software from a local file on
the management workstation, or from an FTP or TFTP server.
New software may be provided periodically on SMC’s web site
(http://www.smc.com).
After upgrading new software, you must reboot the
SMC2552W-G to implement the new code. Until a reboot occurs,
the SMC2552W-G will continue to run the software it was using
before the upgrade started. Also note that rebooting the access
point with new software will reset the configuration to the factory
default settings.
SMC-AP(config)#username bob 6-21
SMC-AP(config)#password smcadmin 6-22
SMC-AP#