User's Manual

Command Line Interface
6-16
System Management Commands
These commands are used to configure the user name,
password, system logs, browser management options, clock
settings, and a variety of other system information.
Command Function Mode Page
Country Setting Sets the country code for correct radio
operation
country Sets the access point country code Exec 6-18
Device
Designation
Configures information that uniquely
identifies this device
prompt Customizes the command line prompt GC 6-20
system name Specifies the host name for the access
point
GC 6-20
snmp-server
contact
Sets the system contact string GC 6-36
snmp-server
location
Sets the system location string GC 6-39
User Access Configures the user name and
password for management access
username Configures the user name for
management access
GC 6-21
password Specifies the password for
management access
GC 6-22
Web Server Enables management access via a
web browser
ip http port Specifies the port to be used by the
web browser interface
GC 6-22
ip http server Allows the access point to be
monitored or configured from a
browser
GC 6-23
Event Logging Controls logging of error messages
logging on Controls logging of error messages GC 6-24
logging host Adds a syslog server host IP address
that will receive logging messages
GC 6-24