User's Manual

216 Operation
Chapter 5 - Command Line Interface
Example
5.18.11 antenna location
This command selects the antenna mounting location for the radio interface.
Syntax
antenna location <outdoor>
• outdoor - The antenna is mounted outdoors.
Default Setting
Outdoor
Command Mode
Interface Configuration (Wireless)
Command Usage
• Selecting the correct location ensures that the AP only uses radio channels that are permitted in
the country of operation.
Example
5.18.12 beacon-interval
This command configures the rate at which beacon signals are transmitted from
the AP.
Syntax
beacon-interval <interval>
interval - The rate for transmitting beacon signals. (Range: 20-1000 milliseconds)
Default Setting
100
Command Mode
Interface Configuration (Wireless)
Command Usage
The beacon signals allow wireless clients to maintain contact with the AP. They may also carry
power-management information.
Example
5.18.13 dtim-period
This command configures the rate at which stations in sleep mode must wake up
to receive broadcast/multicast transmissions.
Enterprise AP(if-wireless g)#antenna id 0000
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless g)#antenna location outdoor
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless g)#beacon-interval 150
Enterprise AP(if-wireless g)#