User's Manual

System Management Commands
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 139
5.5 System Management Commands
These commands are used to configure the user name, password, system logs,
browser management options, clock settings, and a variety of other system
information.
Table 5-5: System Management Commands
Command Function Mode Page
Country Setting
country Sets the AP country code Exec
140
Device Designation
prompt Customizes the command line prompt GC
141
system name Specifies the host name for the AP GC 142
snmp-server contact Sets the system contact string GC 169
snmp-server location Sets the system location string GC 169
Management Access
username Configures the user name for management access GC 142
password Specifies the password for management access GC 143
ip ssh-server enable Enables the Secure Shell server IC-E 143
ip ssh-server port Sets the Secure Shell port IC-E 144
ip telnet-server enable Enables the Telnet server IC-E 144
APmgmtIP Specifies an IP address or range of addresses allowed access to
the management interface
GC 147
APmgmtUI Enables or disables SNMP, Telnet or web management access GC 148
show APmanagement Shows the AP management configuration Exec 148
Web Server
ip http port Specifies the port to be used by the web browser interface GC
144
ip http server Allows the AP to be monitored or configured from a browser GC 145
ip http session-timeout Sets the timeout for the web browser interface GC 145
ip https port Specifies the UDP port number used for a secure HTTP
connection to the AP’s Web interface
GC 146
ip https server Enables the secure HTTP server on the AP GC 146
System Status
show system Displays system information Exec 149
show version Displays version information for the system Exec 150