User's Manual

86 Operation
Chapter 4 - System Configuration
database of detected access points, use the show rogue-ap command from the
Exec level.
To configure the remaining 802.11g radio settings, select the Radio Settings
page.
Enterprise AP(config)#interface wireless g 210
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g)#rogue-ap enable
226
configure either syslog or trap or both to receive the rogue APs detected.
Enterprise AP(if-wireless g)#rogue-ap duration 200
227
Enterprise AP(if-wireless g)#rogue-ap interval 120 228
Enterprise AP(if-wireless g)#rogue-ap scan 228
Enterprise AP(if-wireless g)#rogueApDetect Completed (Radio G) : 5 APs detected
rogueAPDetect (Radio G): refreshing ap database now
Enterprise AP(if-wireless g)#exit
Enterprise AP#show rogue-ap
229
802.11g Channel : Rogue AP Status
AP Address(BSSID) SSID Channel(MHz) RSSI
=======================================================
00-04-e2-2a-37-23 WLAN1AP 11(2462 MHz) 17
00-04-e2-2a-37-3d ANY 7(2442 MHz) 42
00-04-e2-2a-37-49 WLAN1AP 9(2452 MHz) 42
00-90-d1-08-9d-a7 WLAN1AP 1(2412 MHz) 12
00-30-f1-fb-31-f4 WLAN 6(2437 MHz) 16
Enterprise AP#