User's Manual

Figure3‐2‐6:ConfiguringstaticIPaddresses
3.Appendix
3.1Appendix A‐ Enabling Driver Signing
Ifevertheuserwantstostopusingacomputerasahostmachine,theycandisabletestmodewiththefollowing
steps:
1)Runcommandpromptasadministrator(entercmd.exeinsearch
field,rightclickonit)
2)Enterthefollowingtwolines
a)bcdedit.exe–setloadoptionsENABLE_INTEGRITY_CHECKS
b)bcdedit.exe‐setTESTSIGNINGOFF
3.2Appendix B – Setting up TeraTerm
ThestepstoconfigureTeraTermonfirstusearedescri bedbelow.
1.OpenthepreviouslydownloadedTeraTermapplication
2.NavigatetoSetup‐>Terminal
andapplythefollowingsetting(s)
oReceive:AUTO
oCheck“LocalEcho”
3.NavigatetoSetup‐>SerialPortandapplythefollowingsetting(s)
oBaudRate:115200
4.Savethechanges bynavigatingtoSetup‐>SaveSetup
Next,youwillwanttopluginPRS4601viaUSB.Ifyousee
aflashingyellowlight,youwillneedtoinstallnew
firmware.Ifyouseeagreenlight,youcanupdateexistingfirmware.Ifthereisnolightvisible,PRS4601isnot
poweredon,andnothingwillwork.
Ineithercase,openupTeraTermandchoosethecorrectserialport.
Pressenter
afewtimes.Ifthereisnofirmware,youwillgetasimplemessageafterthesecondenterpress,butno
commandswillwork.
IfyouhaveagreenlightonPRS4601,thefollowingcommandswillgivesomeoutputtoTeraTerm: