User's Manual

Alignment

IgniteNet strongly recommends using the ICC-SCOPE-9x50

Alignment Scope for alignment. To install, place the scope

on top of the MetroLinq™ housing and secure it with its

thumb screw.

ignitenet.com5

Note: Do not adjust bolts A

and B without first loosening

1 and 4 respectively.

1. Loosen coarse adjustment bolts 2 and 3 and set initial alignment. Don’tworry,

you don’t have to be too accurate yet. After you have set the coarse

alignment, tighten bolts 2 and 3.

2. Loosen the horizontal fine-tune adjustment bolt 4. Use fine-tune bolt "B" to

optimize the horizontal position. Re-tighten bolt 4.

3. Loosen the vertical fine-tune adjustment bolt 1. Use fine-tune bolt "A" to

optimize the vertical position. Re-tighten bolt 1.

4. Initial alignment should be based on optical or visual alignment. After you

achieve this, repeat steps 2 and 3 while watching the 60 GHz ignal strength

LED. Optimize position to the LED indicator.

5. Ensure all bolts are fully tightened, remove the alignment scope (if installed),

and enjoy Gigabit interference-free wireless.

1 4

2 3