Welcome to MetroLinqTM Interference-Free Gigabit Wireless ignitenet.
Unboxing After opening the box, you will find… • MetroLinqTM • Bracket Kit • POE Power Supply • Power Cable Tools/Items Required • • • • 13 mm Socket Wrench Flat-Head Screwdriver Ethernet Cables (Optional) Alignment Scope ICC-SCOPE-9x50 For helpful training and user-case information, please go to ignitenet.com/support 2 ignitenet.
Assembly The MetroLinq™ bracket is designed for wall and pole mounting (25mm - 75mm pole diameter). Choose what is best for your location and select hardware accordingly. 1. Ensure all four position-locking bolts are tight before installing. 2. Install the bracket onto MetroLinq™ using four M8 bolts, lock washers, and flat washers. 3 ignitenet.
Power Up 1. Connect an Ethernet cable from the MetroLinq™ WAN port (right-side RJ-45) to the POE port on the power supply. 2. Connect Ethernet cable from the “LAN” port on the power supply to your LAN device. 3. Connect the power cord to a nearby AC power source. 4 ignitenet.
Alignment IgniteNet strongly recommends using the ICC-SCOPE-9x50 Alignment Scope for alignment. To install, place the scope on top of the MetroLinq™ housing and secure it with its thumb screw. 1 4 B ! Note: Do not adjust bolts A and B without first loosening 1 and 4 respectively. A 1. 2. 3. 4. 5. 5 2 3 Loosen coarse adjustment bolts 2 and 3 and set initial alignment. Don’tworry, you don’t have to be too accurate yet. After you have set the coarse alignment, tighten bolts 2 and 3.
Software 1. To configure your MetroLinq, connect your computer to the LAN port on the device and configure the IP subnet to match the default IP address of 192.168.1.20 Once configured, direct your web browser to 192.168.1.20 and log in. username: root password: admin123 2. After you have logged in, follow the steps in the Setup Wizard to configure the device for your network. For more configuration details and training, please go to ignitenet.com/support 6 ignitenet.
FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Antenna list: Ant. Brand 1 IgniteNet FS5-19N-120 Ant. Brand 2 P/N P/N Accton 123400001084A Antenna Type Antenna Cable Connector Gain Loss (dBi) (dB) Sector Ant. (PATCH ARRAY) Type-N Antenna Type Connector Dish Ant. N/A 19 1 True Gain (dBi) Remark 18 External (5GHz use) Gain (dBi) Band 1 12.33 Band 4 15.35 Remark Internal (5G&60G use) Professional installation instruction: 1.
