User's Manual
Table Of Contents
- Compliances
- Chapter 1 About This Guide
- Chapter 2 About the IronPoint 200
- Chapter 3 Network Planning
- Chapter 4 Installing the IronPoint 200 Access Point
- Chapter 5 Making a Network Connection
- Appendix A Troubleshooting
- Appendix B Cables
- Appendix C Specifications
- Glossary
- Index
Troubleshooting
April 2004 © 2003 Foundry Networks, Inc. A-3
Lost Password
The only way to recover a lost password is by setting the access point to its default configuration.
Refer to the section “Reset the Access Point Default Settings” for instructions.
Reset the Access Point Default Settings
If all other recovery measures fail and the AP is still not functioning properly, take any of these steps:
• Reset the access point’s hardware using the console interface, web interface, or through a power
reset.
• Reset the access point to its default configuration by pressing the reset button on the back panel
for 5 seconds or more. Then use the default user name “admin” with the password “admin” to
access the management interface.