User's Manual

Foundry IronPoint 200 Installation Guide
4-12 © 2003 Foundry Networks, Inc. April 2004
System Name : Foundry AP
System Location :
System Contact : Contact
System Country Code : GB - UNITED KINGDOM
MAC Address : 00-0C-DB-813-882
IP Address : 192.168.8.10
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.8.254
VLAN State : DISABLED
Management VLAN ID(AP): 1
IAPP State : ENABLED
DHCP Client : DISABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTPS Server : ENABLED
HTTPS Server Port : 443
Slot Status : Dual band(a/g)
Software Version : 01.2.03.00Tw8
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
============================================================
5. Power down the access point.
6. Connect one end of the Ethernet cable to the RJ-45 connector on the access point.
Note: The IronPoint access point also supports power over Ethernet (PoE) to obtain its power
from the RJ-45 port.
7. Connect the other end of the cable to the network subnet for which the access point was
programmed.
8. Power up the access point. It can now be managed using its command line interface ( CLI), Web
interface, or by the IronView Network Manager– IronPoint Edition.
Once the access point is set up with country code and IP address, other parameters can be defined
using one of the following methods:
• A PC running Internet Explorer version 5.0 (and above) Web browser to directly access an
individual IronPoint’s internal Web management interface.
• A PC running IronView® Network Manager to centrally manage the APs on the network.
• A Telnet client to directly access IronPoint’s command line interface (CLI).
Refer to the Foundry IronPoint 200 Quick Start Guide or the Foundry IronPoint 200 User Guide for
details.