User's Manual
Table Of Contents
- Compliances
- Chapter 1 About This Guide
- Chapter 2 About the IronPoint 200
- Chapter 3 Network Planning
- Chapter 4 Installing the IronPoint 200 Access Point
- Chapter 5 Making a Network Connection
- Appendix A Troubleshooting
- Appendix B Cables
- Appendix C Specifications
- Glossary
- Index
Installing the IronPoint 200 Access Point
April 2004 © 2003 Foundry Networks, Inc. 4-9
Figure 4-7. Connecting the External Antenna
2. Insert the external antenna's MC Card connector (otherwise known as a Lucent convertor) to the
external antenna connector.
3. Set the Antenna Mode for the 802.11b/g radio interface to "external" using the CLI, Web
interface, or IronView Network Management.
4. Enable the radio interface using the CLI, Web interface, or IronView Network Management.
Powering Up the Access Point
Prepare the access point for power up by doing the following:
1. Connect the RS-232 console cable to the access point’s console port.
Figure 4-8. Connecting to the Console Port
2. Connect the other end of the RS-232 console cable to your PC's serial port.
3. On your PC console application configure the following communication parameters:
• 9600 bits per second
• 8 data bits
•No parity
• 1 stop bits
5V DC
Power Socket
RJ-45
Connector
Console
Port
Reset
Button
Wall-Mount
Bracket