User's Manual
Table Of Contents
- Compliances
- Chapter 1 About This Guide
- Chapter 2 About the IronPoint 200
- Chapter 3 Network Planning
- Chapter 4 Installing the IronPoint 200 Access Point
- Chapter 5 Making a Network Connection
- Appendix A Troubleshooting
- Appendix B Cables
- Appendix C Specifications
- Glossary
- Index
Installing the IronPoint 200 Access Point
April 2004 © 2003 Foundry Networks, Inc. 4-7
6. Press the access point against the bracket until it snaps into place. The clip locks the access
point in place. Install the 2-56 screws on the sides of the access point.
7. For best coverage, position the antennae at 90 degrees from each other: one antenna up and
one horizontal to the other.
Figure 4-5. Attaching the Bracket to a Suspended Ceiling
Lock Nut
Mounting Bracket
Fastener
Suspended Ceiling T-rail