User's Manual

Foundry IronPoint 200 Installation Guide
4-2 © 2003 Foundry Networks, Inc. April 2004
Figure 4-1. Attaching Feet to the Access Point
2. Set the access point on its four rubber feet on the desktop, shelf, or flat surface, making sure
there is enough clearance around the ventilation holes for proper air flow. For safety reasons,
make sure ventilation holes on the access point are positioned horizontally, not vertically.
3. For best coverage, position the antennas at 90 degrees from each other: one antenna up and
one horizontal to the other.
Attaching the Access Point to a Wall without the Mounting Bracket
Do the following if you want to mount the access point on a wall without the mounting bracket:
1. Use the template in Figure 4-2 to mark the holes for the two slotted key mounting screws on the
wall.
2. Install the two screws for the slotted key mounting holes on the wall.
3. Insert the slotted mounting holes on the back of the access point over the screws.
4. Slide the access point across the screws so the screws move into the narrow part of the slotted
mounting holes. For safety reasons, make sure ventilation holes on the access point are
positioned horizontally, not vertically.
5. For best coverage, position the antennae at 90 degrees from each other: one antenna up and
one horizontal to the other.