User's Manual

Before you begin
Before you set up your headphones, read this section to determine which connection is the most
appropriate for your computer or audio device.
This guide provides procedures for the following tasks:
●
Charging the headphones.
●
Connecting audio in the following ways:
◦
With the audio line-in cable— You can connect two non-Bluetooth audio devices with the
audio line-in cable to communicate with each other. For instructions on using this type of
connection, refer to Chapter 4, “Using the audio line-in cable with other audio devices.”
◦
With the HP Bluetooth audio adapter (select models only)—You can wirelessly
connect the headphones to the Bluetooth audio adapter when the adapter is inserted into the
audio-out (headphone) jack of your device. For instructions on using this type of connection,
refer to Chapter 5, “Using the earbuds with the Bluetooth audio adapter.”
◦
With a Bluetooth-enabled computer—You can wirelessly connect the headphones to a
Bluetooth-enabled computer. For instructions on using this type of connection, refer to Chapter
6, “Using the headphones with a Bluetooth-enabled computer.”
NOTE: If you do not have a Bluetooth-enabled device but would like to add Bluetooth capability,
use an HP Bluetooth audio adapter for best results. Third-party Bluetooth adapters may work, but
they may not be supported.
●
Terminating the headphone wireless connection.
NOTE: If you purchased the HP Bluetooth Pendant Headphones with a Bluetooth computer, you will not
need an adapter to connect your headphones. Refer to Chapter 4 and Chapter 6 for information on
connecting your headphones.
If you purchased the HP Bluetooth Pendant Headphones as an accessory kit, you can use the Bluetooth
audio adapter for additional connections.
WARNING! To reduce the risk of personal injury, adjust the volume before putting on the headphones.
For additional safety information, refer to the Regulatory, Safety and Environmental Notices. These notices
are located on the HP Bluetooth Pendant Headphones Accessory User Guides disc and in Help and
Support.
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Before you begin 3
Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/