User's Manual

Chapter 7 Using HiveManager
78 Aerohive
This chapter explains how to do the following basic tasks:
• Use the console port to change the network settings for the MGT and LAN interfaces
• Power on HiveManager and connect it to a network
• Make an HTTPS connection from your management system to HiveManager and log in to the GUI
It then introduces the HiveManager GUI and includes a summary of the configuration workflow. Finally, the chapter
concludes with procedures for updating HiveManager software and HiveAP firmware. The sections are as follows:
• "Installing and Connecting to the HiveManager GUI" on page79
• "Introduction to the HiveManager GUI" on page82
• "Cloning Configurations" on page83
• "Multiselecting" on page83
• "Sorting Displayed Data" on page84
• "HiveManager Configuration Workflow" on page85
• "Updating Software on HiveManager" on page86
• "Updating HiveOS Firmware" on page87
• "Updating HiveAPs in a Mesh Environment" on page88