User's Manual

Deployment Guide 65

RACK MOUNTINGTHE HIVEMANAGER

You can mount the HiveManager in a standard 19" (48 cm) equipment rack with two rack screws—typically 3/4",

1/2", or 3/8" long with 10-32 threads. The HiveManager ships with mounting brackets already attached to its left

and right sides near the front panel (see Figure1 on page62). In this position, you can front mount the HiveManager

as shown in Figure5. Depending on the layout of your equipment rack, you might need to mount the HiveManager in

reverse. To do that, move the brackets to the left and right sides near the rear before mounting it.

Figure 5 Mounting the HiveManager in an Equipment Rack

1.Position the HiveManager so that the holes in the mounting brackets align with two mounting holes in the

equipment rack rails.

2.Insert a screw through a washer, the hole in one of the mounting brackets, and a hole in the rail.

3.Tighten the screw until it is secure.

4.Repeat steps 2 and 3 to secure the other side of the HiveManager to the rack.

WasherRack

Screw

Mounting

Bracket

Rack Rails