EtherHub-16mi+ Advanced Reference Guide EH1502S E0398-R01 150858-101
Copyright © 1998 by Accton Technology Corporation. All rights reserved. No part of this document may be copied or reproduced in any form or by any means without the prior written consent of Accton Technology Corporation. EtherHub-16mi+ Accton makes no warranties with respect to this documentation and disclaims any implied warranties of merchantability, quality, or fitness for any particular purpose. The information in this document is subject to change without notice.
EtherHub 1500 System Advanced Reference Guide Contents Introduction Introduction 1 Making the Connections Required for System Configuration 1 Onsite Connection Modem Connection In-Band Network Connection Starting the Configuration Program Using Configuration Program System Menu Displaying System Information Changing System Configuration Assigning Trap Managers Downloading System Software Restarting the Agent Reverting Configuration to Factory Settings Save Configuration Reset Configuration Control
EtherHub 1500 System Note: The on-board program only provides access to basic configuration functions. To access the full range of SNMP mangement functions, you must use SNMP-based network mangement software. Accton provides Windows-based SNMP software called AccView/Open with this package. Note that AccView/Opens Hub Manager module can be easily integrated into most third-party management platforms. Advanced Reference Guide 3.
EtherHub 1500 System Menu Thre sho ld Advanced Reference Guide Description (co ntinue d ) Pro vid e s 5 sub -me nus - Syste m, Any Hub , Any Po rt, Se le ct Hub and Se le ct Po rt. This me nu allo ws yo u to se t thre sho ld le ve ls fo r the hub o r p o rt in te rms o f frame s re ce ive d , numb e r o f b yte s, co llisio ns, CRC e rro rs, alig nme nt e rro rs and to tal e rro rs.
EtherHub 1500 System Advanced Reference Guide Field Description SNMP Community Names The community strings authorized for trap management access. All community strings used for IP and IPX Trap Managers must be listed in this table. A community entry authorized for trap management access. Management access is restricted to read-only (RO) or read/write (RW). The status of the current entry can be set to VALID or INVALID. IP management stations selected to receive trap messages from the system.
EtherHub 1500 System Advanced Reference Guide Configuring Port Parameters - Use the Port command from the Control menu to configure the ports for any hub in the stack. (Select the required hub using the and function keys.) This menu provides a brief description of the selected hub, and also allows you to enable/disable any port in the selected hub. Field Description Slave Port Hub Port Pair member serving as the backup link. Hub ID for the slave port. Port identifier for the slave port.
EtherHub 1500 System Advanced Reference Guide Threshold Menu Select the Threshold command from the menu bar to define limits for the parameters monitored by the hub system. Limits can be set for the System (entire stack), Any Hub or Any Port, or a Select Hub or Select Port. Variables to monitor include frames, bytes, collisions, frame allignment errors, CRC errors or total errors. High and low watermarks may be set.
EtherHub 1500 System Advanced Reference Guide DB9 Serial Port to RJ-45 Converter Connector Pin Assignment Description DTR (Data Te rminal Re ad y) 1 RxD (Re ce ive d Data) 2 TxD (Transmitte d Data) 3 SG (Sig nal Gro und ) 4 RI (Ring Ind icato r) 5 CTS (Cle ar-to -Se nd ) 6 RTS (Re q ue st-to -Se nd ) 7 DCD (Data Carrie r De te cte d ) 8 DSR (Data Se t Re ad y) NC RJ-45 Pin Mapping 4 2 3 5 9 8 7 1 6 DB9 PC's COM Port to RJ-45 Converter Connector Pin Assignment Description DTR (Data Te rminal Re ad y) 1
