User`s guide
Table Of Contents
- About this Manual
- Quick Installation Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Using 1Step TM
- Chapter 4 Modem/Fax Setup
- Chapter 5 Fax Operations
- Appendix A Troubleshooting
- Appendix B Modem AT Commands and S-Registers
- Appendix C Specifications
- Appendix D Regulatory Standards Conformance
- Appendix E Product Support Services
- Glossary
- Index
Ethernet+Modem/Fax PC Card User’s Guide
2-2 Installation
Connecting the Adapter Cable to the
PC Card
1. Plug the wide connector on the end of the Y-cable to the mating connector on
the PC Card. Make sure the side of the Y-cable connector with the arrow
heads faces upwards. The cable connectors and card should seat exactly and
click into place. The Y-cable is shown in the following figure:
Figure 2.1 Y-Cable
The Y-cable serves both as a LAN and modem adapter cable. It uses a dual
function twin cable. One is fitted with an RJ-11 plug and the other with an
RJ-45 plug.
2. Plug the RJ-11 male connector into an analog telephone wall jack.
3. Plug the RJ-45 male connector into an RJ-45 network connection.