User guide

Windows P2V Conversions 99
Creating Conversions
Workflow 1
1 Create a CP/SC/DDC task.
2 Set Start at = tomorrow, 12.30.
3 Set Run every = 1h.
4 Save the task.
5 Run the task immediately.
6 The initial step will be performed:
• Next intermediate sync step will be started tomorrow, 12.30
• Start at field will not be changed to meet real initial step start time
Workflow 2
1 Create and configure the CP/SC/DDC task.
2 Save CP/SC/DDC task.
3 Run initial conversion as planned in Start at.
4 Wait for step to finish.
5 Try to change “Start at” and “Run every”.
It is possible to change Start at and Run every values; if you change Run every, the
new value is applied only after one intermediate step will be finished.
For Example:
A task with start time 15:00 and run every 1h, and initial step is finished, and the next
intermediate step is scheduled to start at 16:00.
At 15:10 user changes Run every to 5 minutes.
The next intermediate step will begin at 16:00. After it is completed, the next step will
be started at 16:05.
The initial step will be performed only once. Even if user changes the Start at field after
initial step was performed, it will have no affect (e.g., the intermediate step will be
performed if Start at was changed to future time; nothing will be performed if Start at
was changed to past time).