User guide

Windows P2V Conversions 98
Creating Conversions
Note Different Destination Cutover conversions are not scheduled differently than standard
conversions. The pausing of the task and movement of the target VM are manual tasks
performed at will and communicated to vConverter through the Current Activity field. See
Configuring a Conversion with Different Destination Cutover for more information.
Once set, the task will be shown in the daily schedule on the right side of the Scheduler
tab.
Use the Save icon on the vConverter toolbar to save and set the schedule. You may
change the schedule by clicking the Edit icon.
To schedule Continuous Protection, Synchronized Cutover and Different
Destination Cutover tasks:
1 Configure the scheduler by checking the Start at and Run every checkboxes,
before CP/SC/DDC task is successfully saved.
2 The first conversion happens at the time set in Start at.
3 If Start at is set later than now, the initial step will be started automatically after
task is saved.
4 It is possible to change the schedule:
• after a task is saved
• after the initial conversion is completed
• after some intermediate synchs have completed