User guide

Windows P2V Conversions 89
Creating Conversions
The table below describes the actions available in the Source Drives section.
Select Drives: Each drive in the source system
will be listed. Use the checkbox in this column to
select (or de-select) which drives in the source
system to convert. Select the checkbox in the
header row to select (or de-select) all of the drives
at once.
Volume: The available drives are described in this
column.
File system: Identifies the file system type of the
listed volume.
Size, GB: Identifies the size of the listed volume.
Free, GB: Identifies the amount of free space
available on the listed volume.
Resize: Use the arrows in this field to enter a new
size for a volume. You cannot make a partition
smaller than the amount of data used in the
volume.
Note Resizing volumes to a smaller size is only
possible if you use the flat disk image format. If
this is not part of your default Task Profile,
vConverter prompts you at the time you configure
the resize.
Note File transfer mode is generally faster for resize
operations, but slower for the actual data capture.
vConverter will recommend file-transfer, but either
mode is supported.