User guide

Appendix 1: ISO Image Instructions 151
Configuring the vConverter PE Image
Step 5: Network Identification
The Network Identification section is shown below:
1 Populate the Computer Name, Workgroup, and Primary DNS Suffix
fields as appropriate. Click Set next to each field to save the configuration.
Step 6: Save
1 Click Ok.
Your network configuration should now be properly set.
Adding Drivers to the vConverter PE Image - Using
the WAIK
For multiple conversions to the same type of hardware, it may make more sense to
modify the VistaPE image rather than load the drivers at run time. Using the Windows
Automated Installation Kit (WAIK) from Microsoft, you can add the desired drivers to
the image ISO.
Step 1: Loading WAIK
1 Verify that you have installed vConverter PXE Boot Image (PxeSetup.msi). For
more information, please refer to the section “Installing the PXE Service” in the
vConverter Installation and Setup Guide.
2 Download and Install WAIK (Windows Automation Installation Kit, version
936330AIK):