User's Manual

VDSL Configuration
95
5
VDSL Configuration
VDSL connection parameters can be applied globally to all VDSL ports on the
Gateway.
VDSL Status and Rate Information
This page is used to display the status of the VDSL line, provision the BME and
VDSL ports, run loop-back tests for diagnostic purposes; and also to display the
current rate for various stream types and other VDSL line information.
Use any of the functions listed in the VDSL Status table for the System Provision,
Port Provision, or to stop ports. Or display the basic or detailed list of rate
information.
Figure 5-48 VDSL Status and Rate Information
Field Attributes
VDSL Status, Provisioning, Diagnostics
• Line Status – Displays the line status of the VDSL link, including administrative
status, and port state (Activating, Provisioned or Showtime).
• BME – Includes the following OAM functions for the Gateway’s Burst Mode Engine
(that is, VDSL port controller).
- Reset – Resets power to the BME.
- System Provision – Assigns default values to BME system parameters,
including vendor ID for T1/E1 and ITU, revision number, option mask to enable
PM mode, PM alert and diagnostic modes.
- Port Provision – Loads the parameters stored in FLASH to the VDSL port.