User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
LAN Configuration
69
5
LAN Configuration
The LAN pages are used to configure an IP address for management access
through the LAN interface, configure the local DHCP server, and DNS service.
These pages are also used to configure port connection parameters, including
speed and duplex mode.
LAN Type
LAN Type settings enable VLANs on the units four LAN ports. You may configure up
to four VLANs in total.
Figure 5-25 LAN Type
Field Attributes
• VLAN – Enables or disables VLANs. (Default: Disabled)
• VLAN Type – Selects port-based VLANs by default.
• Port 1~4 – Selects a physical port to apply a VLAN tag to.
• VID – Specifies a VLAN ID. (Range: 0-4095)
• 802.1p – Specifies quality of service level.
• Add – Adds the VLAN to the physical port.