User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
Using the Setup Wizard
41
4
5. Setting WLAN Security (WEP) – Sets the wireless security encryption key for
the wireless network.
Figure 4-11 WLAN Security - WEP
Field Attributes
• None – Disables security on the access point. (Default: Disabled)
• WEP – WEP is used as the multicast encryption cipher.
• Authentication Mode – Defines the mode with which the access point will
associate with other clients.
• Key Mode – Select 64 Bit, or 128 Bit length. Note that the same size of
encryption key must be supported on all wireless clients.
(Default: 64 Bit)
• Active Key – Selects the key number to use for encryption for the VAP
interface. If the clients have all four keys configured to the same values, you
can change the encryption key to any of the eight settings without having to
update the client keys. (Default: Key 1)