User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
Initial Configuration
40
4
3. Enable Local DHCP Service – By default, the Gateway’s is configured to
provide DHCP service to any client attached to the Gateway’s LAN ports. Set the
administrative status of this feature, and click Next.
Figure 4-9 DHCP Setting
4. Set Wireless Settings – The wireless radio on the Gateway is disabled by
default. To enable it check the WLAN Enable box. The access point’s ESSID is
automatically set, but may be changed by altering this field. Click Next to continue
with the wireless setup.
Figure 4-10 WLAN Setting
Field Attributes
• WLAN – Enables the wireless radio interface.
• ESSID – The name of the wireless network service provided by the VAP.
Clients that want to connect to the network must set their SSID to the same
as that of the VAP interface. (Default: ECG9210-04_AP-0; Range: 1-32
characters)