User's Manual

Using the Setup Wizard
39
4
• PPPoE – If you selected PPPoE, the following screen will appear. Fill in the
required settings, and then click Next.
Figure 4-8 WAN Setting (PPPoE)
Field Attributes
• User Name – Sets the PPPoE user name. (Range: 1-32 characters)
• Password – Sets a PPPoE password. (Range: 1-32 characters)
• Password Confirm – Prompts you to re-enter your password.
• Service Name – The service name assigned for the PPPoE connection. The
service name is normally optional, but may be required by some service
providers. (Range: 1-32 characters)
• Access Concentrator Name – The name of the access concentrator to use
in PPPoE Active Discovery Offers (PADO). (Range: 1-32 characters)
• MTU (1400-1492) – Sets the maximum packet size that the WAN port may
transmit. The Maximum Transmission Unit is expressed in bytes. By default,
the Gateway will send several test messages to determine the MTU for the
upstream connection. (Range: 1400-1492 bytes)
• Idle Time (0-99) – The maximum length of inactive time the unit will stay
connected to the service provider before disconnecting. Select
“Auto-reconnect” to reconnect to the upstream gateway whenever an
Internet access request is made. (Range: 1-99 minutes; Default: 2 minutes)