User's Manual

Introduction
20
1
The gateway also includes a wall/ceiling mount bracket illustrated in the picture that
follows. Align the bracket in the direction indicated, marking four screw holes in the
mounting surface with a pencil. Drill four holes in the mounting surface sufficient in size
to accomodate the screws that you are using. If drilling into a wall, make sure to use
wall-plugs as well.
The mounting bracket also includes two clips for attaching the unit to the backet.
Figure 1-5 Mounting Bracket - Front
Before attaching the bracket to the mounting surface be sure to connect the unit to its
required connections, a power source, RJ-11/RJ-45 leads, grounding source, and
power on the unit to make sure that it is functioning and providing connectivity.
Mounting Holes