User's Manual

Introduction
16
1
• Network Address Translation (NAT/NAPT) which enables multiple user Internet
access with a single user account, flexible local IP address administration, and
firewall protection
• Virtual Server which allows remote users access to various services at your site
using a constant IP address
• DMZ Host allows a client to be fully exposed to the Internet for applications which do
not work properly behind a firewall
• Dynamic Host Configuration Protocol (DHCP) for dynamic IP address assignment as
a server or server relay
• TR-069 CPE WAN Management Protocol support for communication between the
Gateway and an Auto-Configuration Server
• TR-098 Multi-Service Delivery Framework for Home Networks
Description of Hardware
This Gateway is a Very High Bit-Rate Digital Subscriber Line (VDSL2) customer
premises equipment (CPE) that can connect to a remote site (via bridging) or to the
Internet (via routing). It transports data over standard telephone wire at a symmetric
data rate up to 100 Mbps downstream and 100 Mbps upstream, and a range up to
200 meters (656 ft).
This unit provides the following ports on the rear panel:
• One RJ-11 port for connection to your VDSL service provider’s incoming line.
• One RJ-11 port for connection to your telephone, modem, or fax machine. The
Gateway includes a built-in POTS voice/data splitter, so no external splitter or
low-pass filter is required.
• Four RJ-45 ports for connection to a 10/100BASE-TX Ethernet Local Area Network.
These ports operate at 10/100 Mbps, half/full duplex. All of these ports support
automatic MDI/MDI-X operation, so you can use straight-through cables for all
network connections. (See “10BASE-T/100BASE-TX Pin Assignments,” page 113.)
• One 802.11b/g antenna for wireless connectivity.
• WPS button for instant wireless connection.
• Wall or ceiling mount kit.
The rear panel also includes a DC power input jack, and a screw hole for grounding the
Gateway to earth.
There is also a reset button on the bottom of unit that can be used to restore the device
to its factory default settings.