User's Manual

System Configuration
108
5
ACS Configuration
Configures parameters for auto-configuration servers (ACS) based on TR-069 (CPE
WAN Management Protocol) and TR-098 (Internet Gateway Device Data Model for
TR-069 Configuration).
TR Settings
This page is used to configure parameters for establishing a connection between the
Gateway and an auto-configuration server.
Click TR. Configure the required parameters, and click Apply.
Figure 5-60 TR Settings
Field Attributes
• TR – Enables or disables connection with an auto-configuration server upon initial
bootup and at the specified periodic report interval or when events occur that must
be reported to the ACS (such as when the broadband IP address of the Gateway
changes). When this parameter is enabled, the ACS can also issue a Connection
Request to the Gateway at any time, instructing it to establish a communication
session with the ACS.
• Enable Periodic Report – Enables periodic reporting of status and performance
information, as well as information used to diagnose connectivity and service
issues.
• Periodic Report Interval – The interval at which the Gateway must initiate a
connection session with the ACS.