User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Network Planning
- Chapter 4: Initial Configuration
- Chapter 5: System Configuration
- Appendix A: Troubleshooting
- Appendix B: Cables
- Appendix C: Specifications
- Glossary
- Index
System Configuration
104
5
QoS Configuration
Quality of Service (QoS) specifies which data packets have greater precedence
when traffic is buffered in the Gateway due to congestion. The Gateway supports
QoS with eight priority queues for each port. Data packets in a port’s high-priority
queue will be transmitted before those in the lower-priority queues.
QoS Settings
This page is used to enable or disable QoS, sets the upstream rate limit, and the
queuing mode.
Click QoS, QoS Settings. Enable QoS, specify the maximum upstream data rate,
select the queueing method, and then click Apply.
Figure 5-54 QoS Settings
Field Attributes
• QoS Enable – Enables or disables QoS settings.
• Upstream Rate Limit – Sets the maximum rate for traffic transmitted onto the
upstream interface. Traffic that falls within the rate limit is transmitted, while
packets that exceed the acceptable amount of traffic are dropped.