System information

Web-Based Management
3-6
Main Menu
Using the on-board Web agent, you can define system parameters, manage and
control the switch, the connected stack and all its ports, or monitor network conditions.
The following table briefly describes the selections available from this program.
Menu Description
System Provides basic system description, including contact information.
Switch Shows hardware/firmware version numbers, power status, and expansion
modules in use.
IP Includes boot state, IP address, and the maximum number of Telnet sessions
allowed.
SNMP Configures communities and trap managers; and activates traps.
Security Sets password for system access.
Upgrade Downloads new version of firmware to update your system.
Configure Saves the switch configuration to a file on a TFTP server. This file can be later
downloaded to restore the configuration.
Address Table Provides full listing of unicast addresses, sorted by address or VLAN.
STA Enables Spanning Tree Algorithm; also sets parameters for switch priority, hello
time, maximum message age, and forward delay; as well as port priority and
path cost.
Bridge Extension Displays/configures extended bridge capabilities provided by this switch,
including support for traffic classes and VLAN extensions.
Priority Configures default port priorities and displays queue assignments.
VLAN Configures VLAN group members and other port-specific VLAN settings.
IGMP Configures IGMP multicast filtering.
Port Enables any port, sets communication mode to auto-negotiation, full duplex or
half duplex, and enables/disables flow control. Also configures broadcast storm
control and port security.
Mirror Sets the source and target ports for mirroring.
Trunk Specifies ports to group into aggregate trunks.
Statistics Displays statistics on network traffic passing through the selected port.