System information

Configuring the Switch
2-41
802.1Q VLAN Current Table Information
This screen shows the current port members of each VLAN and whether or not the
port supports VLAN tagging. Ports assigned to a large VLAN group that crosses
several switches should use VLAN tagging. However, if you just want to create a
small port-based VLAN for one or two switches, you can assign ports to the same
untagged VLAN. The current configuration is shown in the following screen.
Parameter Description
Deleted VLAN Entry Counts The number of times a VLAN entry has been deleted from this table.
VID The ID for the VLAN currently displayed.
Creation Time The value of sysUpTime (System Up Time) when this VLAN was created.
Status Shows how this VLAN was added to the switch.
Dynamic GVRP: Automatically learned via GVRP.
Permanent: Added as a static entry.
Unit Stack unit.
Current Egress Ports Shows the ports which have been added to the displayed VLAN group, where
“1” indicates that a port is a member and “0” that it is not.
Current Untagged Ports If a port has been added to the displayed VLAN (see Current Egress Ports),
its entry in this field will be “1” if the port is untagged or “0” if tagged.
Sorted by VID The VLAN ID number from which the display will start.
[Show] Displays the members for the VLAN indicated by the “Sorted by VID” field.
[More] Displays any subsequent VLANs if configured.
< 802.1Q VLAN Current Table Information >
Deleted VLAN Entry Counts : 0
VID Creation Time Status
----------------------------------------------------------------
1 0 (0 day 0 hr 0 min 0 sec) Permanent
Unit Current Egress Ports Current Untagged Ports
1. 111111111111 111111111111 11-- 111111111111 111111111111 11--
2. ------------ ------------ ---- ------------ ------------ ----
3. ------------ ------------ ---- ------------ ------------ ----
4. ------------ ------------ ---- ------------ ------------ ----
Sorted by VID : 1
[Show] [More]
<Ok>
Use <TAB> or arrow keys to move. <Enter> to select
Port 1 Port 13 Port 25