User Manual

Chapter 3 Using HiveManager
24 Aerohive
This chapter introduces the HiveManager GUI and explains how to do the following basic tasks:
• Using the console port to change the network settings for the MGT and LAN interfaces
• Powering on the HiveManager and connecting it to a network
• Installing the GUI client on your management system and logging in
It then introduces the HiveManager GUI, including a summary of the configuration workflow. Finally, the chapter
concludes with the procedures for updating HiveAP firmware and HiveManager software. The sections are as
follows:
• "Installing and Connecting to the HiveManager GUI" on page25
• "Introduction the the HiveManager GUI" on page28
• "Detaching Windows" on page29
• "Cloning Configurations" on page29
• "Sorting Displayed Data" on page30
• "Multiselecting" on page30
• "HiveManager Configuration Workflow" on page31
• "Updating HiveAP Firmware" on page32
• "Updating Software on the HiveManager" on page33