User Manual

Chapter 3 Adapter Installation and Configuration – Windows

3-1 SYSTEM REQUIREMENTS

In order to install and use the WN3301F PCMCIA card your PC system must meet the following

requirements:

§ A PCMCIA Type II or Type III slot

§ PCMCIA revision 2.10 compliant card and socket services

§ Windows

98 (with the Windows

CD, for use during installation)

§ 500 Kbytes free disk space for utility and driver installation

3-2 INSERTING THE ADAPTER

To insert the WN3301F Network Adapter into a notebook computer, do the following:

1. Locate an available Type II or Type III PCMCIA slot.

2. With the PCMCIA adapter’ s 68-pin connector facing the PCMCIA slot and the “ WN3301F

PCMCIA” label facing up slide the PCMCIA adapter completely into the PCMCIA slot.

Fig. 5 Insert the WN3301F into Notebook

After properly inserting the Network Adapter into your notebook, continue with the WN3301F driver

and PRISM Configuration Utility installation.

NOTE: The PCMCIA slot allows “ hot swap” of PCMCIA adapter. You may insert or remove the

WN3301F / PCMCIA adapter from the slot anytime, even when the power of your computer is on.

NOTE: Windows

98 requires that the Network card and socket services must be compliant with

the PCMCIA revision 2.10 specification. Please check the documentation of the PCMCIA driver

before installing the WN3301F PCMCIA adapter.

NOTE

:FCC RF Radiation Exposure Statement:

This equipment complies with FCC RF radiation exposure limits set forth

for an uncontrolled environment. This equipment should be installed and

operated with a minimum distance of 20 centimeters between the radiator

and your body.