Specifications

Output Submenu
This submenu has adjustments for the 8150 serial digital outputs. The
menu display varies depending on the Output module installed, as
covered in the following discussion.
Output Delay
This softkey appears only if the Enhanced (Frame Delay) Output module
is installed (some 8100s and all 8150s). Press Output Delay to bring up
the Program, Preview, and Aux 1/2 pushknobs. Their default delay
settings are 34 Lines for the program and preview outputs, and Auto
for the Aux 1 and 2 outputs. Use these settings when a one frame delay
through the 8150 is not acceptable or appropriate, as when using
preread, or when using all four Aux outputs with the Combiner On
setting active. The 1 Frame setting provides a one frame delay (from
reference) for the selected output, allowing it to be re-entered and
retimed into your video system.
An output delay control for Aux 3 and 4 does not appear, even if the
option is installed, because these outputs are not capable of one frame
delays. Their outputs are fixed in "Auto" mode and cannot be changed.
NOTE: The Program 2 output is always delayed by one
frame and cannot be changed. If you are using preread, set
the Program 1 output to 34 Lines and feed it to the preread
VTR.
Keypad
Engineering Menu
Figure 5-5 The Output Submenu
Engineering Menu 8150 Technical Guide
5-14
Engineering Setup
9100-0212-04 - May 2000