Specifications

Engineering Menu
Press the green ENG menu button to bring up the Engineering menu.
The softkeys on the right side of the menu display call up submenus that
adjust communications, input and output parameters, and
miscellaneous settings. Use the Software Update softkey to install new
system software. All software updates come with instructions.
A display in the center of the Engineering menu shows the options and
features installed in your 8150, and the current version of Signal Chassis
and Control Panel software.
When you save engineering (ENG) files to disk, you save all the settings
in the Communications, Input, Output, and Miscellaneous submenus.
When you recall an engineering file from disk, it loads all those settings
into memory. See the Disk menu description later in this section for more
information.
NOTE: When you remove an Input module from an input
slot and replace it with an Input module of another type,
the Engineering menu settings for the original Input
module are no longer valid. If you change an input module
location or type, make sure that you reconfigure the
Engineering menu and save the new setup as an
Engineering file. The Personality menu Input Names and
Input Assignments are saved as personality files, however,
and are independent of the Engineering settings.
Keypad
Engineering Menu
Figure 5-1 The Communications Submenu
Engineering Menu 8150 Technical Guide
5-2
Engineering Setup
9100-0212-04 - May 2000