Specifications

Transition Control Buttons
The Transition Control button group includes four rows of buttons. Lit
LEDs in the buttons indicate the current transition settings.
The top row BKND, KEY 1, and KEY 2 buttons select the M/E bus(es)
for the active transition. Any combination of these buttons can be lit
simultaneously. If PRIORITY is lit, the transition will exchange the
priority of the two key buses. For example, if Keyer 2 is over, or has a
higher priority than, Keyer 1, you can transition them so that Keyer 1 is
over, or has a higher priority than, Keyer 2.
Below the bus select buttons, the MIX, WIPE, EFFECT, NAM, and FAM
buttons select the type of transition, both for the M/E buses and the
PGM/PST/DSK buses. You can, however, only select EFFECT as the
transition type if the DVE option board is installed, and you cannot
transition M/E priority as an EFFECT. You can press AUTO TRANS or
move the fader bar to execute the transition. Pressing CUT performs the
transition instantly, regardless of the transition type selected.
8150
SHOW
STATUS
MIX WIPE EFFECT
BKND KEY 1
KEY 2
PRIORITY
NAM FAM
AUTO
TRAN
CUT
Figure 4-12 The Transition Control Buttons
Control Panel 8150 Technical Guide
4-20
System Overview
9100-0212-04 - May 2000